NBase MegaSwitch 100


Please click picture to request more specific information

NH2007

NH2007/FO

Licensed to Speed


Overview

The NBase NH2007 MegaSwitch is a Fast Ethernet store-and-forward switch featuring five 100Base-TX ports or five 100Base-FX ports and two optional high speed 100Base-TX/FX expansion ports. Each 10OMbps RJ-45 port supports a Fast Ethernet segment, with up to 2048 nodes with near zero latency. The two additional slots can be used for 10OBase- TX/FX optional plug-in modules for scalability and distance extension. The NH2007/FO drives both multimode and singlemode fiber to 2km and 10km, respectively.

Features

Description

The NH2007 increases the bandwidth of Fast Ethernet installations by dividing the network into segments and insulating each from the others' local traffic. In addition, it enables the extension of Fast Ethernet LANs to greater distances. The Switch's parallel store-and-forward architecture with direct source port-to-destination port transfer eliminates delays in data transfer. ts proprietary hardware enables the NH2007 to handle wire speed reception, including Broadcast and Multicast frames destined to more than one output port, through a filtering and for-warding rate of 500,000 packets per second.

NBase Selective Flow Control prevents lost packets due to buffer overload, a critical feature for sliding windows NOSs such as TCP/IP and Novell 4.2.

Powerful custom filtering provides Virtual LAN capabilities (confined within the switch). The Switch supports Virtual Broadcast domains, Virtual Security domains and custom filters based on desti- nation MAC addresses.

Complete runt and CRC filtering provides greater reliability, while port and management LEDs facilitate installation, maintenance and diagnostics.

The MegaSwitch 100 is fully managed through NBase's SNMP-based NMS, MegaVision; however, it also supports any standard SNMP-based Network Management System.

Application

Typical network applications for the NH2007 would include: Each port on the NH2007 can be con- figured for Full Duplex operation for supporting high-end workstations. Maximum cable length from the Fast Ethernet port to a workstation/hub is 100m over 100Base-TX and 400m over 10OBase-FX. Full Duplex eliminates this distance limitation, enabling trans- mission distances exceeding lOOkm over singlemode fiber optic cable. With the fiber optic Fast Ethernet plug-in modules, transmission distances of up to lOOkm are achievable in single- mode fiber optics.


Send me some more Info.
commkmj@kmj.com